National Instruments NI 5670 用户手册

9.

Click OK.

10. Verify that the new names for both modules are displayed.

You must create a MAX association between the NI 5610 upconverter 
module and the NI 5421/5441/5442 AWG module to control both 
hardware modules as a single NI RF signal generator. Complete steps 11 
through 13 to make this association.

11. Right-click NI PXI-5610 and select Properties.

12. In the NI 5610 Device Properties dialog box, use the drop-down 

listbox to specify the NI 5421/5441/5442 AWG module that is 
connected to the NI 5610 by front panel coaxial cables. Refer to 
section 

 for more 

information about cable connections.

If you rename the NI 5421/5441/5442 AWG module after association, you must 

repeat the association. Association between NI 5670/5671/5672 hardware modules is lost 
when a previously associated AWG module is renamed.

13. Click OK to close the dialog box.

To verify your device configuration, use the NI-RFSG test panel in MAX 
to generate a simple signal using the NI RF signal generator hardware. The 
NI-RFSG test panel tests both NI 5670/5671/5672 hardware modules as a 
single instrument. Complete the following steps to use the NI RF signal 
generator test panel.

This test requires front panel interconnection, as shown in Figure 5, and the 

association of an NI 5421/5441/5442 AWG module with the NI 5610 upconverter module 
as described in the Associate the Upconverter with the AWG Module section.

1.

Right-click the NI PXI-5610 upconverter module, and select 
Test Panels.

2.

In the NI PXI-5670/5671/5672 tab of the Test Panels dialog box, 
specify a frequency and a power level for signal generation.

Running the test panel generates a signal from the RF OUTPUT front panel 

connector. Disconnect any equipment that can be damaged by the test signal prior to 
running the test panel.