Konica Minolta di1610f um gdi 1.1.1 用户手册
Copier Control Panel Operations (PC Print Mode)
4
Di1610f GDI Printer Controller
4-5
4.6
Using the Bypass Tray
Use the procedure described below to print onto paper that is fed
automatically (up to 10 sheets at a time) from the bypass tray.
automatically (up to 10 sheets at a time) from the bypass tray.
1
On your computer, display the “Setup” tab of the printer driver, and
then specify “Bypass” for the
then specify “Bypass” for the
Paper Source
2
Execute the print operation from your computer.
3
When the message “LOAD PAPER”
appears on the copier’s display,
load paper onto the bypass tray.
appears on the copier’s display,
load paper onto the bypass tray.
H
This causes the print operation
to be performed using the paper
from the bypass tray.
to be performed using the paper
from the bypass tray.
4
Repeat step 3 as many times as
necessary until printing of the
document is complete.
necessary until printing of the
document is complete.
Note
Be sure to execute the print operation from the computer first, and then
place the paper onto the bypass tray. If there is already paper on the
bypass tray when you execute the print operation, remove it, and then
place it again onto the bypass tray.
Be sure to execute the print operation from the computer first, and then
place the paper onto the bypass tray. If there is already paper on the
bypass tray when you execute the print operation, remove it, and then
place it again onto the bypass tray.
The bypass tray can be loaded with a maximum of 1 envelope, 5 OHP
transparencies, or 10 sheets of plain paper or cards.
transparencies, or 10 sheets of plain paper or cards.