Kompernass parkside pss 310-kh 3123 planslip 用户手册

Take note of the mains voltage. The voltage must agree with that shown on the identification plate (equipment 
shown as 230 V can also be used with 220 V).

SWITCHING ON AND OFF

SWITCH ON SANDER

=

press switch 

SWITCH OFF SANDER

=

press switch 

again

You can set the required speed using the adjuster wheel 

(see Fig 

) as required. As the setting depends on 

what kind of material you are working with, use the recommendations and examples given in Tips and Tricks.

Note: before fitting a new sanding sheet, remove dust and dirt from the base 

.

1. Lift both clips 

to open them to insert a new sanding sheet or change the sanding sheet for 

use on a different material.

2. Push the sanding sheet 

under the open clip at one end and clamp it securely on the base by 

moving the clip down again.

3. Do the same at the other end. Make sure that the sanding sheet 

is tight against the base. See Figures 

and 

.

4. Important! - The holes in the sanding sheet 

and the base 

must align for the dust to be extracted through the 

base. See Figure 

.

Different materials need different grades of sanding sheets. To determine which grade is suitable for your work,
please read our recommendation in Tips and Tricks.

•

DUST EXTRACTION WITH PAPER DUST BAG

Push the paper dust bag 

on to the adapter 

. Ensure that the adapter fits correctly into the holder.

Clip the dust bag with the adapter to the side of the sander.

•

DUST EXTRACTION WITH VACUUM CLEANER

For dust extraction using a vacuum cleaner use the appropriate connector – see Figure 

. Attach the adapter to 

the end of the vacuum cleaner hose and clip it to the side of the equipment.

1. Clean the sander regularly. For the best results do this straight after the work has been completed.
2. Do not allow liquids to get inside the sander. Use a soft cloth for cleaning the housing. Do not use petrol,

solvents or cleaners that may attack the plastic.

3. Air vents must always be clear and clean.

4 manual GB  (+IRL)_Helv  17.06.2003  14:21 Uhr  Seite 5