MINOURA hyperbrain 用户手册

The display mode shifts each time the button is pressed (O-M-A-D-T), and the corresponding data is simultaneously dis-

played on the sub-display.  If the Mode button is held down for over 2 seconds, 24-hour clock will be displayed.

Measuring of the Trip Distance and Elapsed Time is simultaneously started or stopped when the Start/Stop button is pressed.

During operation the speed scale symbol flickers.

When this button is pressed in the stop state in each mode, the following value can be changed;

• In (O) mode: Wheel Circumference

• In 24-hour Clock mode: 24-hour Clock

• In (T),(D) or (A) mode: on/off the Automatic Start/Stop

Select any mode except Total Distance (O), and press the Mode button and Start/Stop button simultaneously.  The memo-

rized Trip Distance, Elapsed Time, Average Speed and Maximum Speed will be erased. (When the two buttons are pressed in

“O” mode, the wheel circumference stored will be displayed.)

When the AC button on the backside of the computer is pressed, all data stored in memory (trip distance, speed scale, wheel

circumference and clock time) will be erased.  All displays illuminates, then the “mile/h” symbol alone appears.  This opera-

tion should be executed only when irregular display occurs or no display appears.  Since all the memories are erased, set the

main unit again according to "Main Unit Preparation".

If your RDA InterRim Ergo is later than 2001 model and has a hole on the Roller Support

Stay, you can install HyperBrain on it.  PLEASE NOTE: There is no hole on this model

before 2000.  Please look over and read the “Installing HyperBrain” section on the previous

page first to know how you should do it.

1

2

3

4

(Fig. F)

(Fig. G)

(Fig. H)

(Fig. I)

Put the RDA Bracket on the backside of the Roller Support Stay, and tighten with the

supplied M4 Bolt (larger one). (see Fig. F)

Install the Speed Sensor on the RDA Bracket. (see Fig. G)

Install the Magnet Sensor on a spoke of your rear wheel (usually you should choose

the opposite spoke to the air valve for better balance).  Be sure you set it at same height

as the Speed Sensor. (see Fig. H)

To install the sensor, remove the Nut from the Magnet Sensor and sandwitch the spoke

with both parts, then tighten it firmly.  Put the spoke into the cut out section on the Nut.

Face the magnet to the Speed Sensor side.

Set the Speed Sensor position so the clearance between the Speed Sensor and the

Magnet Sensor is around 2 or 3 mm. (see Fig. I)

!

To avoid the problem of th sensor and magent hitting together, keep

the clearance as suggested above.

If the clearance is too wide the sensor will not work.