Panasonic ERGC71 操作指南
15
English
Lubrication
• Apply the oil to the clipper before and after each use.
• Make sure that the clipper is turned off.
1
Remove the blade.
2
Apply a drop of the oil to each
indicated point.
indicated point.
3
Attach the blade to the main
body, turn on the power and
allow to run for approximately
5 seconds.
body, turn on the power and
allow to run for approximately
5 seconds.
Removing and mounting the blade
Removing the blade
Hold the clipper with the switch facing
upward and push the blade with your
thumb while catching the blade in your
other hand.
Hold the clipper with the switch facing
upward and push the blade with your
thumb while catching the blade in your
other hand.
Mounting the blade
Fit the mounting hook (B) into the blade mounting (A) on the
clipper and then push in until you hear a click.
Fit the mounting hook (B) into the blade mounting (A) on the
clipper and then push in until you hear a click.
Troubleshooting
Perform the following actions.
If the problems still cannot be solved, contact the store where
you purchased the unit or a service centre authorized by
Panasonic for repair.
If the problems still cannot be solved, contact the store where
you purchased the unit or a service centre authorized by
Panasonic for repair.
Problem
Action
The blade has not been
cleaned properly.
cleaned properly.
When the clipper is very dirty,
remove the blade and wash with
water. (See page 14.)
remove the blade and wash with
water. (See page 14.)
Makes a loud sound.
Confirm that the blade is properly
attached.
attached.
The clipper has become
blunt.
blunt.
Replace the blade.
(See this page.)
Clean the blade and apply oil.
(See pages 14 and 15.)
(See this page.)
Clean the blade and apply oil.
(See pages 14 and 15.)
Clipper stopped
functioning.
functioning.
Operating time is short.
Charge the clipper.
Or use with the AC operation.
(See page 10.)
Charge the battery for
approximately 16 hours
continuously to rejuvenate it.
If few uses remain even after
charging, the battery has reached
the end of its life. (Fluid may be
leaking due to degradation at the
end of battery life.)
Contact an authorized service
centre for repair.
Or use with the AC operation.
(See page 10.)
Charge the battery for
approximately 16 hours
continuously to rejuvenate it.
If few uses remain even after
charging, the battery has reached
the end of its life. (Fluid may be
leaking due to degradation at the
end of battery life.)
Contact an authorized service
centre for repair.
ER-GC71_51_EU.indb 15
2016/01/28 17:44:58