Panasonic ERGC71 操作指南
16
English
Problem
Action
The clipper cannot be
charged.
charged.
Push the appliance plug into the
main body all the way and make
sure the charge indicator lamp
(
main body all the way and make
sure the charge indicator lamp
(
) glows.
Charge within the recommended
charging temperature of 0 °C to
35 °C.
charging temperature of 0 °C to
35 °C.
Clipper can be used for
only about 10 minutes
even after charging.
only about 10 minutes
even after charging.
Have the battery replaced by an
authorized service centre.
authorized service centre.
Blade life
Blade life varies according to the frequency and period of use of
the clipper.
For example, the blade life is approximately 2 years when using the
clipper for 20 minutes twice a month. Replace the blades if cutting
efficiency reduces substantially despite proper maintenance.
the clipper.
For example, the blade life is approximately 2 years when using the
clipper for 20 minutes twice a month. Replace the blades if cutting
efficiency reduces substantially despite proper maintenance.
Battery life
Battery life will vary according to the frequency and length of use.
If the battery is charged once a month, the service life will be
approximately 3 years.
If the operating time is significantly shorter even after a full charge,
the battery has reached the end of its life.
If the battery is charged once a month, the service life will be
approximately 3 years.
If the operating time is significantly shorter even after a full charge,
the battery has reached the end of its life.
Removing the built-in rechargeable battery
Remove the built-in rechargeable battery before disposing of
the clipper.
Please make sure that the battery is disposed of at an officially
designated location if there is one.
This figure must only be used when disposing of the clipper, and
must not be used to repair it. If you dismantle the clipper yourself,
it will no longer be waterproof, which may cause it to malfunction.
the clipper.
Please make sure that the battery is disposed of at an officially
designated location if there is one.
This figure must only be used when disposing of the clipper, and
must not be used to repair it. If you dismantle the clipper yourself,
it will no longer be waterproof, which may cause it to malfunction.
• Remove the clipper from the AC adaptor.
• Slide the power switch to turn on the power and then keep the
power on until the battery is completely discharged.
• Perform steps 1 to > and lift the battery, and then remove it.
• Take care not to short circuit the positive and negative terminals
of the removed battery, and insulate the terminals by applying
tape to them.
tape to them.
ER-GC71_51_EU.indb 16
2016/01/28 17:44:58