Cisco 48 port High Performance Mixed Media Gigabit Ethernet Interface Module 规格指南
2-31
Catalyst 6500 Series Switch Module Guide
OL-6265-01 Rev. A0
Chapter 2 Ethernet and Gigabit Ethernet Switching Modules
Gigabit Ethernet Switching Modules
Figure 2-32 24-Port Gigabit Ethernet Switching Module (WS-X6724-SFP)
The front panel LEDs are described in
48-Port Gigabit Ethernet Switching Module (WS-X6748-SFP)
The 48-port Gigabit Ethernet switching module (WS-X6748-SFP) provides
48 switched, Gigabit Ethernet ports. (See
48 switched, Gigabit Ethernet ports. (See
.) The 48 ports support
hot-swappable Small Form-Factor Pluggable (SFP) 1000BASE-SX,
1000BASE-LX/LH, and 1000BASE-ZX optical transceivers. The
WS-X6748-SFP module has dual fabric channels interface and requires the
Supervisor Engine 720.
1000BASE-LX/LH, and 1000BASE-ZX optical transceivers. The
WS-X6748-SFP module has dual fabric channels interface and requires the
Supervisor Engine 720.
The QoS port architecture (Rx/Tx) for this module is 1q8t/1p3q8t.
Figure 2-33 48-Port Gigabit Ethernet Switching Module (WS-X6748-SFP)
The front panel LEDs are described in
16-Port Gigabit Ethernet Switching Module (WS-X6816-GBIC)
The 16-Port Gigabit Ethernet switching module (WS-X6816-GBIC) provides
16 switched, full-duplex Gigabit Ethernet ports that you can configure with any
combination of 1000BASE-SX, LX/LH, and ZX GBICs, copper GBICs, or
CWDM GBICs. (See
16 switched, full-duplex Gigabit Ethernet ports that you can configure with any
combination of 1000BASE-SX, LX/LH, and ZX GBICs, copper GBICs, or
CWDM GBICs. (See
.)
Note
CWDM GBICs are used with the CWDM Passive Optical System. For more
information on the CWDM Passive Optical System, refer to the Installation Note
for the CWDM Passive Optical System.
information on the CWDM Passive Optical System, refer to the Installation Note
for the CWDM Passive Optical System.
STATUS
WS-X6724-SFP
24 PORT GIGABIT ETHERNET-SFP
99886
STATUS
WS-X6748-SFP
48 PORT GIGABIT ETHERNET-SFP
144612