Cisco 7000 SERIES PA 8 PORT T1 MC ADAPTER WITH CSU DSU 规格指南
4-17
Multichannel DS1/PRI Port Adapter Installation and Configuration
OL-3525-03
Chapter 4 Configuring the Multichannel DS1/PRI Interfaces
Checking the Configuration
To check the interface configuration using show commands, proceed to the following section, “
.”
Checking the Configuration
After configuring the new interface, use the show commands to display the status of the new interface
or all interfaces, the ping command to check connectivity, and the loopback command to verify the
physical interface.
or all interfaces, the ping command to check connectivity, and the loopback command to verify the
physical interface.
•
•
•
•
Using show Commands to Verify the New Interface Status
provides a list of show commands and their functions. This will help you to
verify that new interfaces are configured and operating correctly and that the multichannel DS1/PRI port
adapter appears correctly in them. Sample displays of the output of selected show commands appear in
the sections that follow. For complete command descriptions and examples, refer to the publications
listed in the
adapter appears correctly in them. Sample displays of the output of selected show commands appear in
the sections that follow. For complete command descriptions and examples, refer to the publications
listed in the
Note
The outputs that appear in this document may not match the output you receive when running these
commands. The outputs in this document are examples only.
commands. The outputs in this document are examples only.
Table 4-5
Mapping of Cable Length Values to Range
Range (feet)
Value
0 to 133
133
133 to 266
266
266 to 399
399
399 to 533
533
533 to 655
655