Yamaha Pro Yamaha DGX-660B 业主指南
Keyboard Stand Assembly
DGX-660 Owner’s Manual
14
Set
ting Up
4
Attach the back board.
Attach the back board, using the screws
t
. Check
the back-to-front orientation for the side boards.
Make sure the non-colored surface is facing down.
Make sure the non-colored surface is facing down.
5
Put the keyboard on the stand.
Check the back-to-front orientation for stand, and
carefully place the keyboard on the side boards.
Slowly move the keyboard so that the holes on the
bottom of the keyboard are properly aligned with
the holes on the angle brackets.
carefully place the keyboard on the side boards.
Slowly move the keyboard so that the holes on the
bottom of the keyboard are properly aligned with
the holes on the angle brackets.
4
t
6 x 30 mm roundhead screws
5
At least
10 cm
10 cm
At least
10 cm
10 cm
Be sure to place your hands at
least 10 cm from either end of the
keyboard when positioning it.
least 10 cm from either end of the
keyboard when positioning it.
• Be careful not to drop the back board or touch the
sharp metal fittings.
• If you have purchased a pedal unit (sold separately),
attach the pedal unit before proceeding to the next step.
Refer to the instructions provided with your pedal unit.
Refer to the instructions provided with your pedal unit.
• For information on the pedal functions, refer to page 22.
• Be careful not to drop the keyboard or to get your fin-
gers caught between the keyboard and the stand
parts.
parts.
• Do not hold the keyboard in any position other than
the position shown in the illustration.
CAUTION
NOTE
CAUTION