Canon Speedlite 430EX III-RT 业主指南

18

Set the power switch to <K>.

X

The flash recycling starts.

X

During recycling, <G> is 
displayed on the LCD panel. When 
flash recycling is complete, this 
indicator disappears.

 

The status of the flash-ready lamp 
changes from off to green (Quick 
flash ready) to red (fully charged).

 

You can press the test flash button 
(flash-ready lamp) to fire a test flash.

The Quick flash function enables flash shooting when the flash-ready lamp is 
lit green (before the flash is fully charged). Quick flash is available regardless 
of the camera’s drive mode setting. The flash output will be approx. 1/2 to 1/3 
of the full output, but it is effective for shooting with a shorter firing interval.
During manual flash shooting, this function is available when the flash 
output is set to 1/4 to 1/128. Note that you cannot use Quick flash 
during wireless flash shooting.

To save battery power, the power will turn off automatically after approx. 90 sec. 
of idle use. To turn on the Speedlite again, press the camera’s shutter button 
halfway or press the test flash button (flash-ready lamp).
During radio transmission wireless master flash shooting (p.57) or during linked 
shooting (p.69), the time until auto power off takes effect is approx. 5 min.

A test flash cannot be fired when the camera’s 3/1/o/7/2 timer 
is active.

For the display of <G> when set as the master unit during radio 
transmission wireless shooting, see page 54.