MartinLogan Motion® 35XT 业主指南

7

BREAK IN
Allow approximately 72 hours of break-in at 90 
dB (moderate levels) before any critical listening.

INSTALLING ON A FLAT SURFACE
If you have a surface that provides a wide, level, 
and stable platform, the speaker can be placed 
directly on top. When using the speaker in this 
configuration, affix the pads to the bottom of the 
speaker at the rear contact points (fig. 5). Note: 
This speaker is not magnetically shielded and 
therefore should not be placed directly beside or 
atop a CRT television.

Toe-In: When installed on a surface and used as 
front channels we recommend aiming your speak-
ers towards the primary listening position.

WARNING! Installation other 
than that described in the body of 
this document requires specific  
documentation from MartinLogan.

How do I clean my speakers?
Use a dust free cloth (such as a micro fiber cloth) 
or a soft brush to remove dust from your speakers. 
Do not spray any kind of cleaning agent on or in 
close proximity to the drivers.

Could you suggest a list of suitable elec-
tronics and cables ideal for MartinLogan 
speakers? 
We have no favorites and use electronics and 
cables quite interchangeably. We would suggest 
listening to a number of brands—and above all 
else—trust your ears. Dealers are always the best 
source for information when purchasing additional 
audio equipment.

Is there likely to be any interaction 
between my speakers and the televi-
sion in my A/V system? 
Yes. These speakers are not shielded and should 
be kept at least 2 feet away from a CRT television.

Will exposure to sunlight affect the life 
or performance of my speakers? 
We recommend against placing any loudspeaker 
in direct sunlight. Ultraviolet (UV) rays from the sun 
can cause deterioration of cabinet, speaker cones, 
etc. Small exposures to UV will not cause a prob-
lem. Filtering of UV rays through glass will greatly 
reduce the negative effects.