Oppo RMK-UDP205 业主指南
Rack Mount Kit Installation Guide
Part Number: RMK-205
Contents: (2) rack mount brackets, (2) rack mount spacers, and (4) side panel screws.
Installation:
1. Remove the 4 screws from the UDP-205’s left
and right panels. Save the screws for Step 3.
2. Position one bracket to the right side of the
player, and align the top hole in the bracket with
the hole in the player’s side panel, as shown in
Figure 1. Secure the bracket to the player using
the side panel screws supplied with the rack
mount kit. Do not use the side panel screws
removed from the player because those are
too short. Install the other bracket to the left
side similarly.
3. Position the shorter spacer over the top of the
front panel of the player, as shown in Figure 2.
Use two screws saved from Step 1 to secure the
spacer at each end to the Left and Right
brackets. Install the taller spacer under the front
panel similarly.
4. The completed unit should look like Figure 3. It
is ready to be mounted using the screws that
came with your equipment rack.
Caution:
The player needs to fit into a 3U rack space. It is
recommended to leave a blank or ventilated 1U
space below and above the player to allow for
better cooling.
The player should not be installed directly above a
heat-generating device such as a power amplifier
or A/V receiver.
Please also check the rack manufacturer’s
instructions and allow for enough ventilation
(Bottom, Top and Sides).
OPPO Digital Inc.
162 Constitution Dr.
Menlo Park, CA 94025, U.S.A.
www.oppodigital.com
Figure 1
Figure 2
Figure 3