Recon Dynamics LLC B0-0003 用户手册
PROXBOX INSTALLATION GUIDE
© 2018 Recon Dynamics, LLC | v1.2
4
INSTALLATION
P
ROX
B
OX
I
NSTALLATION
• Use the mounting flanges as a drill template and center punch to mark locations to
drill. Mount the ProxBox using the vibration mounting kit. Ensure all metal surfaces
are touched up with paint after drilling to avoid corrosion.
are touched up with paint after drilling to avoid corrosion.
• Route supplied power cable from ProxBox to the truck's main battery, the bare end
(no connector) is to be routed.
Ensure when routing the power cable that it is well protected, so nothing can
damage it once installed.
damage it once installed.
Do not connect power to the ProxBox until patch antenna is connected.
• Secure cable to the truck using tie wraps. It is recommended to use wire loom for
added protection.
• It is best to leave the power cable at full length and just bundle up excess cable with
a wire tie. But, if necessary, cut excess length from the cable.
• Strip the pre-tinned wire leads back 2-3 inches. The 18 AWG red “hot” wire requires
and inline 10A fuse added (not included).
Shock hazard! Be very careful when connecting leads to the battery.
• Attach the black lead to ground post of the battery. Attach red lead to hot post of
battery. Ensure both connections are bolted tightly to battery and power cable fuse
is routed to eliminate potential damage.
is routed to eliminate potential damage.
P
ATCH
A
NTENNA
I
NSTALLATION
• Before mounting ensure antenna cable will easily reach the ProxBox connector
marked “Ant”.
• Attach Patch antenna using a minimum of (2) screws to a solid surface, (4) screws
are recommended though. Use the antenna as a drill template and center punch to
mark locations to drill. Do not over tighten screws or bolts as the antenna is plastic
and will be damaged. Ensure all metal surfaces are touched up with paint after
drilling to avoid corrosion.
mark locations to drill. Do not over tighten screws or bolts as the antenna is plastic
and will be damaged. Ensure all metal surfaces are touched up with paint after
drilling to avoid corrosion.
Do not mount antenna using glue, tape or tie wraps.
• Route cable from patch antenna to ProxBox.
• Secure excess cable neatly using wire ties. It is recommended to use wire loom for
• Secure excess cable neatly using wire ties. It is recommended to use wire loom for
added protection.