Diffraction Limited MD1 用户手册
Hardware Installation
13
The sensor should be wired between the REED1 and GND terminals.
Power Supply Wiring
The controller card requires +12VDC for operation. Please be sure to observe
the correct polarity when connecting the power. The board draws 75 mA at 12V.
It can operate down to about +9VDC.
The standard 12V DC battery will provide sufficient power for the motor and the
controller board. If you use an alternative power source, make sure it can handle
the current surge when the motor starts working; if the voltage drops too much it
may cause the controller board to reset.
It is recommended that a switch be added to the battery leads to preserve battery
life when the unit is not operating. This switch can be mounted onto the side of
the fiberglass motor enclosure.
the correct polarity when connecting the power. The board draws 75 mA at 12V.
It can operate down to about +9VDC.
The standard 12V DC battery will provide sufficient power for the motor and the
controller board. If you use an alternative power source, make sure it can handle
the current surge when the motor starts working; if the voltage drops too much it
may cause the controller board to reset.
It is recommended that a switch be added to the battery leads to preserve battery
life when the unit is not operating. This switch can be mounted onto the side of
the fiberglass motor enclosure.
DIP Switch
Switch 4 switches between Channel A and Channel B. Both the Rotation
Controller board and the Shutter Controller board must be selected to the same
channel.
Switches 1 through 3 are currently not used.
Controller board and the Shutter Controller board must be selected to the same
channel.
Switches 1 through 3 are currently not used.