Racom RIPEX-154 用户手册
the network defined by IP and Mask of one of the interfaces (Radio, ETH), otherwise the packet is
discarded.
Each line in the routing table defines a Gateway (the route, the next hop) for the network (group of
addresses) defined by Destination IP and Mask. When the Gateway for the respective destination IP
address is not found in the Routing table, the packet is forwarded to the Default gateway. When Default
gateway is not defined (0.0.0.0), the packet is discarded.
The network (Destination and Mask) can by specified in both formats. Either 10.11.12.13/24 in Destin-
ation or 10.11.12.13 in Destination and 255.255.255.0. in Mask columns. RipEX displays and converts
both formats. There is also a balloon tip while the cursor is in the specific line on the Mask. It shows
which IP addresses are included in the network which is routed to the respective Gateway.
discarded.
Each line in the routing table defines a Gateway (the route, the next hop) for the network (group of
addresses) defined by Destination IP and Mask. When the Gateway for the respective destination IP
address is not found in the Routing table, the packet is forwarded to the Default gateway. When Default
gateway is not defined (0.0.0.0), the packet is discarded.
The network (Destination and Mask) can by specified in both formats. Either 10.11.12.13/24 in Destin-
ation or 10.11.12.13 in Destination and 255.255.255.0. in Mask columns. RipEX displays and converts
both formats. There is also a balloon tip while the cursor is in the specific line on the Mask. It shows
which IP addresses are included in the network which is routed to the respective Gateway.
Interface
It may happen that networks defined by IP and Mask of router interfaces overlap. In such a case it is
necessary to define to which interface (Radio, ETH) the packet should be forwarded.
When Auto is selected, the packet is forwarded automatically to the correct interface.
necessary to define to which interface (Radio, ETH) the packet should be forwarded.
When Auto is selected, the packet is forwarded automatically to the correct interface.
Note
You may add a note to each route with your comments up to 16 characters (only ASCII is supported)
for your convenience. (E.g. “Central station” etc.). Following characters are not allowed:
for your convenience. (E.g. “Central station” etc.). Following characters are not allowed:
" (Double quote)
` (Grave accent)
\ (Backslash)
$ (Dollar symbol)
; (Semicolon)
` (Grave accent)
\ (Backslash)
$ (Dollar symbol)
; (Semicolon)
Active
You may tick/un-tick each route in order to make it active/not active. This feature is advantageous e.g.
when one needs to redirect some route temporarily.
when one needs to redirect some route temporarily.
Modify
Edit Delete Add buttons allow to edit or add or delete a line. One may order the lines using up and
down arrows.
down arrows.
Buttons
•
Apply - applies and saves the changes.
•
Cancel - restores original values.
•
Find - finds (highlights the respective line in the table) the route for a specific IP address if exists.
•
Check routing - highlights duplicate routes for specific IP if they exist.
105
© RACOM s.r.o. – RipEX Radio modem & Router
Advanced Configuration