Zebra Technologies Corporation FX7400 用户手册

Installation and Communication

3 - 3

Position the mounting plate on a flat surface (wall or shelf). Position the release tab on the top. See 

Mark the hole locations using the mounting plate as a guide. See 

. Remove the mounting plate and 

drill holes (appropriate for the surface material) at the marked locations.

Reposition the mounting plate over the mounting holes and secure using the supplied fasteners (as 
appropriate for the surface material). 

Position the reader by aligning the markers on the metal base plate and the wall bracket, positioning the 
key-slot holes over the mounting screws. Gently slide the reader down (see 

) to lock into place.

To remove the reader, press the release tab and slide the reader up while gently pulling out.

For wood surfaces, drill two 1/8" diameter by 7/8" deep holes. For drywall/masonry surfaces, drill two 
3/16" diameter by 7/8" deep (min) holes and install using the provided anchors.

Release Tab

Mounting Holes

Screw Head Stops
(4 typical)

Use a hand screw driver to install the mounting plate (do not use a power driver). Do not use 
excessive torque, and tighten the screws so that they are just snug on the screw head stops (see 

). If the reader does not engage the mounting plate, loosen the screw(s) 1/8 to 1/4 turn and 

try again.

Mount the reader with the cable connections up or down, depending on the installation requirements.