Netgear 09100105 用户手册

2-18

Safeguarding Your Network

You can add WPS-enabled and non-WPS-enabled client devices.

To add an additional wireless client device that is WPS enabled:

1. Follow the procedures in 

 or 

.

2. For information about how to view a list of all devices connected to your router (including 

wireless and Ethernet-connected), see 

.

If you are connecting a combination of WPS-enabled clients and clients that are not WPS enabled, 
you cannot use the WPS setup procedures to add clients that are not WPS enabled.

To connect both non-WPS-enabled and WPS-enabled clients to the WNR2000v2 router:

1. Configure the settings of the WNR2000v2 router (shown in the Wireless Settings screen) for 

.

When you change security settings, all existing connected wireless clients that do not share 
those settings are disassociated and disconnected from the router.

2. For the non-WPS-enabled devices that you wish to connect, open the networking utility, and 

follow the utility’s instructions to enter security settings.

3. For the WPS-enabled devices that you wish to connect, follow the procedures in 

The WNR2000v2 router automatically preserves the settings you configured in 

clients share the same security settings (for more information, see 

Note: Your wireless settings do not change when you add an additional WPS-enabled 

client unless you have cleared the Keep Existing Wireless Settings check box (in 
the Wireless Settings screen). If you do clear the check box, a new SSID and a 
passphrase are generated, and all existing connected wireless clients are 
disassociated and disconnected from the router.