Netgear 11200165 用户手册

You can connect to the network using WPS either with a push button or a PIN.

Push Button. This is the preferred method. See the following section, 

.

Entering a PIN. See “WPS PIN Entry” on page

WPS Button 

Any wireless computer or wireless adapter that will connect to the router wirelessly is a client. 
The client must support a WPS button, and must have a WPS configuration utility, such as 
the NETGEAR Smart Wizard or Atheros Jumpstart.

On the router main menu, select Add 
a WPS Client, and then click Next. 

By default, the Push Button 
(recommended) radio button is 
selected.

Either click the onscreen button or 
press the WPS button on the front of 
the router.

The router tries to communicate with the client (the computer that wants to join the 
network) for 2 minutes.

Go to the client wireless computer, and run a WPS configuration utility. Follow the utility’s 
instructions to click a WPS button.

Go back to the router screen to check for a message.

The router WPS screen displays a message confirming that the client was added to the 
wireless network. The router generates an SSID, and implements WPA/WPA2 wireless 
security. The router will keep these wireless settings unless you change them, or you 
clear the Keep Existing Wireless Settings check box in the WPS Settings screen.

Note the new SSID and WPA/WPA2 password for the wireless network. You can view these 
settings in the Wireless Settings screen. See “Manually Configuring Your Wireless Settings” 
on page

To access the Internet from any computer connected to your router, launch a browser such 
as Microsoft Internet Explorer or Mozilla Firefox. You should see the router’s Internet LED 
blink, indicating communication to the ISP.

WPS
button