Bibliotheca RFID Library Systems AG ADS100 用户手册
User Manual for Andromeda, RFID Gate Sensor
Bibliotheca RFID Library Systems AG, CH-6315 Oberägeri, Switzerland
ads100-user.doc Page 3 of 6
Basically, certain guidelines must be followed during the installation and usage
phases. Usually a site inspection takes place prior to installation, where the posi-
tioning and cabling logistics are determined. Despite this, certain preparatory
steps can be taken in advance to better facilitate installation and start-up.
phases. Usually a site inspection takes place prior to installation, where the posi-
tioning and cabling logistics are determined. Despite this, certain preparatory
steps can be taken in advance to better facilitate installation and start-up.
NOTE: It is important that the gate sensor is positioned in the vicinity of a well-
observed area (such as the librarian’s desk) to facilitate a better view over those
persons who have triggered an alarm.
observed area (such as the librarian’s desk) to facilitate a better view over those
persons who have triggered an alarm.
2.1 Technical specifications
The gate width between the two antennas, center to center is 90 cm. The anten-
nas of the gate sensor are connected to a separate reader module. Please refer
to the reader module manual for further details.
The gate width between the two antennas, center to center is 90 cm. The anten-
nas of the gate sensor are connected to a separate reader module. Please refer
to the reader module manual for further details.
The reader module is equipped with a binary input/output signal used for the op-
tical and acoustic signals. Each active antenna is equipped with a light and a
buzzer/horn to emit these signals.
tical and acoustic signals. Each active antenna is equipped with a light and a
buzzer/horn to emit these signals.
3.0 Installation Recommendations
Consideration of the following construction tips can assist in achieving optimal
functionality of the gate sensor. There are a few illustrations attached with regard
to the installation:
Consideration of the following construction tips can assist in achieving optimal
functionality of the gate sensor. There are a few illustrations attached with regard
to the installation:
1.
The equipment should be installed in a "freestanding" way; i.e. there
should not be large metal objects within a radius of 3 ½ feet. In order to
achieve the desired mechanical stability of the equipment, a firm anchoring
method should be chosen. Care should be taken not to damage existing in-
frastructure under the floor such as pipes, cables and reinforcements.
Electrical connections to existing infrastructure under the floor should be
avoided. If the antennas are delivered with a base structure, then the base
should be screwed to the antennae. In this case, drilling into the floor is not
necessary.
should not be large metal objects within a radius of 3 ½ feet. In order to
achieve the desired mechanical stability of the equipment, a firm anchoring
method should be chosen. Care should be taken not to damage existing in-
frastructure under the floor such as pipes, cables and reinforcements.
Electrical connections to existing infrastructure under the floor should be
avoided. If the antennas are delivered with a base structure, then the base
should be screwed to the antennae. In this case, drilling into the floor is not
necessary.
2.
Construction of the equipment on surfaces where heating systems are lo-
cated under the floor must be cleared with Bibliotheca first.
cated under the floor must be cleared with Bibliotheca first.