Mobilicom ltd. MCU-30 用户手册
MCU-30 User Manual
Page : 26 / 51
This page contains information which is protected by copyright and is proprietary to Mobilicom Ltd.
No part of this document
may be used, copied, disclosed or conveyed to another party without prior written consent of Mobilicom Ltd
9 Mobile MESH (Multi-Point-to- Multi-Point) Network
A Mobile MESH network is a cluster of MCUs over a radio link. The cluster includes
at least 2 MCU units and can range up to 32 MCUs. Each MCU unit receives from,
and transmits to, all other members of the cluster within the reception range.
at least 2 MCU units and can range up to 32 MCUs. Each MCU unit receives from,
and transmits to, all other members of the cluster within the reception range.
The system is synchronized using a GPS or 1PPS External source. The MCU has an
internal GPS receiver and an external connector for GPS antenna (passive or active).
internal GPS receiver and an external connector for GPS antenna (passive or active).
In the Mobile MESH network, the transmission bandwidth is pre-allocated to each
member of the cluster; this allocation is called a transmission vector and can be
configured using the MC-EMA. All MCUs in the cluster must have the same
configuration (Frequency, Profile and Transmission Vector) with only one difference,
unit ID number.
member of the cluster; this allocation is called a transmission vector and can be
configured using the MC-EMA. All MCUs in the cluster must have the same
configuration (Frequency, Profile and Transmission Vector) with only one difference,
unit ID number.
An MCU can be a “listener” only, receiving the information from all other members of
the cluster without consuming any bandwidth by not transmitting. In such
configuration the “listener” unit cannot be monitored via other units (over the air), it
cannot be seen in the link monitor screen since it does not transmit at any time. This
application can be used when transmitting broadcast data to several units, when
there is no need for sending data to the other direction. It can also be used when a
unit is needed as a relay only unit.
the cluster without consuming any bandwidth by not transmitting. In such
configuration the “listener” unit cannot be monitored via other units (over the air), it
cannot be seen in the link monitor screen since it does not transmit at any time. This
application can be used when transmitting broadcast data to several units, when
there is no need for sending data to the other direction. It can also be used when a
unit is needed as a relay only unit.
After powering up the MCU, it waits for synchronization (1PPS). As soon as the MCU
is synchronized (regardless of other unit
is synchronized (regardless of other unit
s’ synchronization) it starts to transmit in its
dedicated time slot(s).
NOTE – The MCU can be synchronized by an external 1PPS source. For further
information on this option, contact:
information on this option, contact: