Redline Communications Inc. AN100UXA 用户手册
User
AN-100U/UX Base Station
Manual
70-00058-01-04
Proprietary Redline Communications © 2010
Page 32 of 136
April 19, 2010
Reset Switch
The Reset switch is recessed in the front panel of the terminal. To operate the switch,
use a small narrow object (i.e., bent paper clip) to depress the switch.
use a small narrow object (i.e., bent paper clip) to depress the switch.
Table 19: System - Front Panel Reset Switch
Operation
Result
Depress switch
less than 3
seconds
seconds
Short-reset. A short-reset is equivalent to cycling the
terminal power off/on. Statistics counters are reset.
Depress switch
longer than 3
seconds
seconds
Long-reset. A long-reset sets the IP address and
password to the factory defaults. Refer to Troubleshooting
section.
section.
3.1.6 Grounding Connection
A ground terminal is located on the rear of the terminal. Correct grounding is very
important for safe operation of wireless equipment.
important for safe operation of wireless equipment.
3.1.7 Console Port
The console port requires a crossover (null modem) cable to connect directly to a PC
serial port emulating a VT-52 or VT-100 terminal. The following table lists the default
settings for the Console port:
serial port emulating a VT-52 or VT-100 terminal. The following table lists the default
settings for the Console port:
Table 20: System - AN-100U/UX Console Port Default Settings
Baud
57,600
Data Bits
8
Flow Control
None
Parity
None
Stop Bits
1
The following table lists the Console port pinout and associated signals.
Table 21: System - AN-100U/UX Console Port (RS-232) Pinout
Pin
Name
RS232
V.24
Description
2
RXD
BB
104
Receive Data
3
TXD
BA
103
Transmit Data
5
GND
AB
102
System Ground
Note: V.24 column is ITU-TSS V.24 circuit name.
3.2
Radio Outdoor Unit (ODU)
3.2.1 Transceiver
The radio modem is housed in a weatherproof aluminum alloy case. The modem
features are listed in the following sections.
features are listed in the following sections.
TB Radio
The TB3x3yF7 series of radios are for use only with the AN-100U. These radios operate
on 24 VDC and can be mounted using the standard and heavy-duty antenna mounting
brackets.
on 24 VDC and can be mounted using the standard and heavy-duty antenna mounting
brackets.