Redline Communications Inc. AN50 用户手册

 

 

AN-50 User Manual 

16/51  

line Communications 

 

…..solving the first mile challenge. 

 

 
Note that the antenna can also be mounted onto another pole separate from the 
one supplied with the system.  Contact Redline for different antenna mounting 
options. 
 

Running the IF Cable 
 
The system is equipped with a 100 foot of RF cable to interconnect the transceiver 
and terminal.  The following steps define the cable installation: 
 

1.  Run the cable through the antenna pole as shown below. Add extra cable 

length to produce a drip-loop, as shown, to prevent water from 
accumulating onto the connector. The IF cable is equipped with 75 ohm 
F-type connectors at both ends, however, it is important to note that one 
end of the cable is designated for outdoors, as it is a specialized weather 
proof design, while the other end is to be connected to the indoor terminal 
unit. A label is attached to one end of the cable to clearly indicate the 
connector that is intended for outdoors. Make certain the ‘Outdoor’ label 
is attached to the end of the cable that you plan to connect to the radio.   

 

 

 

2.  Connect the F-type male connector from the cable to the female connector 

attached to at the bottom of the transceiver.  Note the connector at the top 
end of the transceiver is connected via cable to the antenna itself.