Redline Communications Inc. AN50 用户手册
AN-50 User Manual
18/51
Red
line Communications
…..solving the first mile challenge.
Host
Computer
Figure 8 AN-50 connected to host computer.
The remote terminal may also be connected to a simple hub, for distribution to
several computers in a local network configuration, as shown in Figure 9. If the
terminal is connected to simple, hub, then a cross-over cable is required.
Third Party
Hub
Host
Computer
Host
Computer
Figure 9 AN-50 connected to a hub.
Figure 10 provides an illustration of the pin-out designation for the AN-50 LAN
interface, to help you establish other implementations that are not addressed in
this manual.
Figure 10 AN-50 LAN Ethernet Port pin-out.
Now connect the AC cord to the 120 VAC outlet and turn the terminal on using
the toggle switch at the rear of the unit. The system “Pwr” LED should illuminate
green to indicate proper power to the unit. If this LED is not on and/or the “Fault”
LED illuminates red, then there is a problem with the unit. Refer to the
diagnostics section, Section 7 on page 31, for further details on how to address
system faults. The system is now ready to be configured.