Redline Communications Inc. AN80I 用户手册

70-00072-01-04-DRAFT 

 

May 7, 2007 

Page 41 of 91

 

 

This section describes the configuration screens used to setup a PMP deployment. 

Click 

Configure

 

System

 

in the menu to view and adjust configuration settings for general 

system identification, Ethernet, and the wireless interface (partial screen shown below). 
The highlighted fields are specific to PMP deployments. 

 

: PMP - Ethernet Settings 

Polling Interval: Enter the SNTP polling interval (hours). 

Mgmt. Tag Enable: Check 

 this box to enable VLAN tagged traffic. 

The Mgmt Tag Enable setting is disabled (factory default) when shipped from the factory 
or following a long-reset operation. In this mode the sector controller and subscriber 
stations can be managed through the local Ethernet port using untagged traffic. Over-the-
air management is possible only after creating a pass-through group and pass-through 
connections for each subscriber station. 
When Mgmt Tag Enable is enabled, this sector controller or subscriber station can be 
managed only using VLAN traffic tagged with the value specified in the Mgmt. VID 
field. Over-the-air management is possible only after creating a VLAN tagged group and 
VLAN tagged connections for each subscriber station.