Redline Communications Inc. AN80IE 用户手册
&
User
AN-80i
Manual
70-00072-01-07
Proprietary Redline Communications © 2010
Page 20 of 106
Sept 18, 2008
3.3
System Information
3.3.1 General Information
Click
General
Information
to view the system overview screen (read-only). Refer to the
System
Configuration
screen for information about changing these settings.
Dashboard
The dashboard display at the top of the
General
Information
screen shows summary of
important operational information including: the unit IP address, operating frequency,
current time (web user's platform), wireless status, Ethernet status, Received Signal
Strength Indication (RSSI), Signal to Interference, Noise, and Distortion Ratio (SINADR),
and the radio temperature.
current time (web user's platform), wireless status, Ethernet status, Received Signal
Strength Indication (RSSI), Signal to Interference, Noise, and Distortion Ratio (SINADR),
and the radio temperature.
Figure 7: Web - General Information Dashboard
IP Address (top left of screen): Current IP address setting of this unit.
Wireless Frequency (top center of screen): User-assigned RF channel frequency.
Time (top right of screen): Displays time obtained from user's Web browser.
Wireless Link LED
The Wireless Link LED lights solid green when the wireless link is established. If the
LED is off, it may indicate one of the problems listed in the following table:
Wireless Link LED
The Wireless Link LED lights solid green when the wireless link is established. If the
LED is off, it may indicate one of the problems listed in the following table:
Table 2: Wireless Link LED Diagnostics
Symptom
Possible Problem
Solution
No wireless
link
Link name does not match. A PTP
wireless link can be established
only between pairs of AN-80i
systems having identical Link
Name settings.
only between pairs of AN-80i
systems having identical Link
Name settings.
Enter identical Link Name field settings
on master and slave units. To establish a
PTP wireless link between an AN-50e
and AN-80i system, the AN-80i Link
Name field must be blank (delete all
characters).
PTP wireless link between an AN-50e
and AN-80i system, the AN-80i Link
Name field must be blank (delete all
characters).
Remote system is malfunctioning
or is not powered-on.
Verify operation of remote system.
The propagation path is blocked.
Clear path or re-locate unit.
The transceiver is malfunctioning.
Repair/replace unit.
Antenna is not aligned with the
remote system.
Re-align the antenna.
Wireless Signal LED
The wireless signal LED lights when a wireless link is established. Signal indications are
different based on the Adaptive Modulation setting:
The wireless signal LED lights when a wireless link is established. Signal indications are
different based on the Adaptive Modulation setting: