Captivate Network 6F127021 用户手册
each cab. This is approximate and may require some variations during the
installation. After the antennas are mounted, the coaxial cables will need to be
connected to the antennas and passed through the 1 ½ -inch drilled hole to the
Access Points. The antenna cable has a very low voltage (approximately 50
millivolts max.). Use minimum of 1-inch conduit for the antenna if required
by the local code.
installation. After the antennas are mounted, the coaxial cables will need to be
connected to the antennas and passed through the 1 ½ -inch drilled hole to the
Access Points. The antenna cable has a very low voltage (approximately 50
millivolts max.). Use minimum of 1-inch conduit for the antenna if required
by the local code.
7. Project start date will be coordinated by the Captivate Installation Coordinator.
Questions regarding scope prior to the installation start date should be addressed
to:
to:
Patti Rossetti – (978) 845-5081 – prossetti@captivate.com
8. Onsite activities and escalations should be coordinated with the Captivate Project
Supervisor onsite. If the Project Supervisor is not available, issues can be
escalated to the Installation Coordinator, or the Field Operations Manager:
escalated to the Installation Coordinator, or the Field Operations Manager:
Patti Rossetti – (978) 845-5081 –
prossetti@captivate.com
Mark Dodge – (978) 845-5039 –
mdodge@captivate.com
Canada Compliance Information
This device complies with Industry Canada License-exempt RSS Standards. Operation is subject the
following two conditions: (1) this device may not cause interference, and (2) this device must accept any
interference, including interference that may cause undesired operation of the device.
This device has been designed to operate with the antennas listed below, and having a maximum gain of 2
dB. Antenna not included in this list or having a gain greater than 2 dB are strictly prohibited for use with
this device. The required antenna impedance is 50 ohms.
Nearson
Antenna
–
S131AM-2450R
To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that
the equivalent isotropically radiated power (e.i.r.p.) is not more than permitted for successful
communication.
FCC Compliance Information
NOTE: This equipment has been tested and found to comply with the limits for a Class
A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. Operation of this equipment in
a residential area is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense
A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. Operation of this equipment in
a residential area is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense
.
Changes or modifications not expressly approved by Captivate Network could void the
user’s authority to operate the equipment.
user’s authority to operate the equipment.