Renishaw plc RMP60V2 用户手册

RMP60 can be user configured using trigger

logic to allow multiple RMP60s to be used

with a single RMI.

Multiple probe mode

Radio turn on cannot be used in multiple probe

mode.

To allow multiple probes/single RMI in close

proximity, 16 choices of ‘mode-on’ colours are

available – each representing a different

machine tool installation. The choices are

shown on the next page and in ‘Changing

probe settings’.

All probes on a single RMI machine should be

set to the same ‘mode-on’ colour choice; any

multiple probes on adjacent machines should

all be set to an alternative ‘mode-on’ colour

choice. Multiple probe mode will not appear in

the configuration of the probe if radio turn on

has been selected.

Any number of RMP60s set to ‘mode-off’ can

be used alongside RMP60s set to ‘Multiple

probe mode’.

Only one of the multiple probes per machine
will need partnering as, by configuring multiple
probes to a single ‘mode-on’ choice, all probes
have the same identification. The probe to be
partnered, is partnered after selection of
multiple probe on in ‘Changing probe settings’.

There is no limit to the number of probes that
can be used with a single RMI as long as they
all have the same ‘mode-on’ colour choice.

All RMP60s are factory-set to ‘mode off’.

The addition of further probe(s) into a single
probe installation requires all probes to be
re-configured to the same multiple probe
‘mode-on’ choice and the repartnering of
one of the probes to the installed RMI.

The addition of further probes (or replacements)
into a multi probe installation is achieved simply
by reconfiguration to the same ‘mode-on’

colour choice.