The CBORD Group Inc. VRC2100 用户手册
VRC2100 Vending Reader
8
Installation Guide
7. Access the Telnet Configuration tab. After the XPORT connects to
the Telnet session, a blank page will appear. Click Connect and then
quickly press the [Enter] key when prompted with Press Enter for
Setup Mode.
For daisy-chain installations, only the Master needs these settings.
The Slaves use an address in the communications packet. For Slave
units, skip the Telnet settings.
quickly press the [Enter] key when prompted with Press Enter for
Setup Mode.
For daisy-chain installations, only the Master needs these settings.
The Slaves use an address in the communications packet. For Slave
units, skip the Telnet settings.
8. Text will appear showing the current settings. A menu will appear at
the bottom of the tab:
Change Setup:
0 Server
1 Channel 1
3 E-mail
5 Expert
6 Security
7 Defaults
8 Exit without Save
9 Save and exit
Your choice?
Change Setup:
0 Server
1 Channel 1
3 E-mail
5 Expert
6 Security
7 Defaults
8 Exit without Save
9 Save and exit
Your choice?
9. Select 0 Server to set the network settings for the VRC2100. The IP
address is unique to each installation and requires your network
administrator to assign an IP address to the VRC2100. The Gateway
IP address and Netmask are also supplied by your network
administrator.
administrator to assign an IP address to the VRC2100. The Gateway
IP address and Netmask are also supplied by your network
administrator.
IP Address: Enter the IP address.
Set Gateway IP Address: Enter the Gateway IP address.
Netmask: Number of Bits for Host Part (0=default) (10)
The network administrator will supply this number.
Set DNS Server IP addr (N)?
Change Telnet/Web Manager password (N)?
10. Select 1 (Channel 1) and enter the following settings:
Baudrate (9600) ?
I/FMode(4C)?
Flow(00)?
Port No (3700) ? This setting must match the Odyssey Port
number in Port Setup.
ConnectMode (C2) ?
Send ’+++’ In Modem Mode (N) ?