Honeywell International Inc. CS22A 用户手册

©2010 Honeywell International Inc.   All rights reserved. 

ACC-PT-QS Rev (a) 4/10

When there is no activity within a specified time period, the scanner enters a low power mode.  The default time out period 
is one  hour.  Pull the scanner’s trigger to power the scanner back up.  If the scanner was linked to the Access Point when it 
went to “sleep,” it will re-link as long as it is in range.

If multiple scanners use the same Access Point, it is possible to inadvertently unlink a scanner that is in “sleep” mode, that 
has a dead battery, or is in the process of getting a new battery.  To prevent this from happening, you can disable the sleep 
mode (time out) by scanning the No Time Out bar code below. 

If you know that your scanner is not going to be used for a while, you can unlink the scanner by scanning the Unlink Scan-
ner bar code below. 

When you press the Page button, the scanner associated with that Access Point will begin beeping (3 
short and 1 long beep).  If you pull the trigger on a scanner that is beeping in response, that scanner 
will stop beeping.  Pressing the Page button a second time will also stop the scanner’s beeping.   

Scan a bar code to set the brightness of your Page button.

If you want a carriage return (CR) to display after the bar code data on your output scan the Add CR Suffix bar code below.  
Scan the Remove Suffix bar code to remove the suffix.

This bar code resets all standard product default settings.

Note: Resetting standard defaults disconnects the scanner from the Access Point.  Scan the Linking bar code to re-establish a 

connection.  Refer to your User’s Guide at 

 for additional information about product defaults.

Page 
button