Adtran TRC3202 用户手册
Section 4, Network Turnup Procedure
TRACER 2210/3202 System Manual
32
© 2002 ADTRAN, Inc.
61280012L1-1A
1.
INTRODUCTION
This section discusses the installation process of the TRACER 2210/3202 system.
2.
TOOLS REQUIRED
The tools required for the installation of the TRACER 2210/3202 are:
•
Wire stripper (for cable assembly)
•
Wire cutter (for cable assembly)
•
Crimping tool (for cable assembly)
•
#2 Phillips screwdriver (for cable assembly)
3.
UNPACK AND INSPECT THE SYSTEM
Each TRACER 2210/3202 is shipped in its own cardboard shipping carton. Open each carton carefully and
avoid deep penetration into the carton with sharp objects.
avoid deep penetration into the carton with sharp objects.
After unpacking the unit, inspect it for possible shipping damage. If the equipment has been damaged in
transit, immediately file a claim with the carrier, then contact ADTRAN Customer Service (see Warranty
and Customer Service information in the front of this manual).
transit, immediately file a claim with the carrier, then contact ADTRAN Customer Service (see Warranty
and Customer Service information in the front of this manual).
Contents of ADTRAN Shipment
Your ADTRAN shipment includes the following items:
•
(1) TRACER 2210 Data Interface Unit (DIU)
•
(1) 6’ Wallmount power supply (for DIU)
•
(1) TRACER 3202 RF Mast Unit (RIU)
•
(1) Pre-threaded mast unit bracket
•
(2) Bracket clamps
•
(4) CPC crimping pins
•
(1) Terminal block for custom cable assembly - inside TRACER 2210 box
•
(1) The TRACER 2210/3202 System CD including the User Manual and Quick Start Guide - inside
TRACER 2210 box
TRACER 2210 box
Changes or modifications not expressly approved by ADTRAN could void the user’s
authority to operate the equipment.
authority to operate the equipment.
To prevent electrical shock, do not install equipment in a wet location or during a
lightning storm.
lightning storm.