Zebra Technologies Corporation MD-BTC2TY 用户手册
28
QL 420 User’s Guide
Wireless Local Area Network (WLAN) Module Using CF
Radio
Radio
The following section only applies when the CF (Compact Flash) WLAN module (With
FCC ID: I28MD-QL4137) is installed in the QL 420 printer (note that only one of the
radio options can be installed in the printer at one time). The FCC ID number label is
on the front of the module and can be read with the module installed.
FCC ID: I28MD-QL4137) is installed in the QL 420 printer (note that only one of the
radio options can be installed in the printer at one time). The FCC ID number label is
on the front of the module and can be read with the module installed.
WARNING: Use of the QL 420 with the radio module marked
“with FCC ID: I28MD-QL4137” meets the FCC requirements for
radio frequency (RF) radiation exposure in the standard body
worn configuration with no minimum separation. In this
configuration, which applies whether the belt clip or shoulder
strap is used, the face of the printer from which paper is
transported is facing away from the user’s body. The standard
configuration must always be used when the printer is body
worn.
The printer with this radio option has been SAR tested. The
maximum SAR value measured was 1.1W/kg averaged over 1
gram.
radio frequency (RF) radiation exposure in the standard body
worn configuration with no minimum separation. In this
configuration, which applies whether the belt clip or shoulder
strap is used, the face of the printer from which paper is
transported is facing away from the user’s body. The standard
configuration must always be used when the printer is body
worn.
The printer with this radio option has been SAR tested. The
maximum SAR value measured was 1.1W/kg averaged over 1
gram.
European Regulatory Information for this Radio
AUS
B
DK
FIN
F
D
GR
IRE
I
LUX
NL
P
E
S
UK
Note: -Member states in the EU with restrictive use for this device are
crossed out!
This device is also authorized for use in all EFTA member states (CH, ICE,
LI, NOR)
crossed out!
This device is also authorized for use in all EFTA member states (CH, ICE,
LI, NOR)
Europe – EU Declaration of Conformity
This device complies with the essential requirements of the R&TTE
Directive 1999/5/EC. The following test methods have been applied in
order to prove presumption of compliance with the R&TTE Directive 1999/
5/EC:
Directive 1999/5/EC. The following test methods have been applied in
order to prove presumption of compliance with the R&TTE Directive 1999/
5/EC:
• EN 60950: 2000
Safety of Information Technology Equipment
• EN 300 328-2 V1.2.1 (2001-12)
Technical requirements for spread-spectrum radio equipment
• EN 301 489-17 V1.2.1 (2002-08)
EMC requirements for spread-spectrum radio equipment.
0982
Important Notice:
This device is a portable RF printer intended for
commercial and industrial use
This device is a portable RF printer intended for
commercial and industrial use
in all EU and
EFTA member states except in France where
restrictive use applies.
restrictive use applies.