Applied Concepts Inc ACMI005 用户手册
S
Sport2 Owner’s Manual
Holdover Delay: The time the speed reading is held after the target is lost and before the display
screen clears. If off, the speed displays until the next speed is acquired.
screen clears. If off, the speed displays until the next speed is acquired.
Trigger Function: The Trigger settings are Con (Continuous), SS (Start / Stop), and Loc (Lock).
The trigger settings function as follows:
The trigger settings function as follows:
Transmit
Trigger Option
Action
OFF
Con
Pull to transmit,
release to hold.
SS
Pull and release to transmit,
Pull and release to hold.
ON
Loc
Pull to lock and release the speed.
Note: When the Loc setting is selected in the Option Menu, the Transmit function is
turned on the same as if the silver Transmit button is pressed. Clicking the trigger
locks and releases the speed.
locks and releases the speed.
Stopwatch Mode: This is available using the optional stopwatch cable. The stopwatch may be
set to lap or split timer. The timer displays in the MESSAGE WINDOW. Press and hold the
stopwatch trigger for 1 second to stop the timer and go back to radar mode.
set to lap or split timer. The timer displays in the MESSAGE WINDOW. Press and hold the
stopwatch trigger for 1 second to stop the timer and go back to radar mode.
Lap Timer: each press of the stopwatch trigger displays the time since the last trigger
press, and resets the timer to 0.00.00 in the background.
Split Timer: each press of the stopwatch trigger displays the current cumulative time.
Timer Display Under 10 minutes:
9.59.99 PEAK 8888
XMIT
8888
Timer Display Over 10 minutes:
99.59.9 PEAK 8888
XMIT
8888
Serial Port Format: The “-“ (dash) is for no serial output, the A format is for Target Speed, and
the AP format is for Peak Speed.
the AP format is for Peak Speed.
** The Reset Confirmation step displays when the Reset option is set to YES.
• If YES, then the confirmation SURE? displays.
• To reset all settings to the factory defaults, select YES and then pull the trigger to
• To reset all settings to the factory defaults, select YES and then pull the trigger to
exit.
• To not change the settings, select no and pull the trigger to exit.
10