Applied Concepts Inc ACMI006 用户手册
Low-End Patrol Speed Selection
The PS 5/20 key is used to set the low-end patrol speed. The right
two digits of the patrol window refer to the current low-end patrol
speed of either 5 mph, 10mph, or 20 mph. For example, sensitivity 1
with
5 mph low-end patrol speed would be indicated by: SEn 1 5
(Fig 12). Sensitivity 1 with 20 mph low-end patrol speed would be:
SEn 1 20 (Fig 13). During VSS operation this function is not
required and thus is not available. During VSS operation, when the
PS 5/20 key is pressed, SP will be momentarily displayed.
two digits of the patrol window refer to the current low-end patrol
speed of either 5 mph, 10mph, or 20 mph. For example, sensitivity 1
with
5 mph low-end patrol speed would be indicated by: SEn 1 5
(Fig 12). Sensitivity 1 with 20 mph low-end patrol speed would be:
SEn 1 20 (Fig 13). During VSS operation this function is not
required and thus is not available. During VSS operation, when the
PS 5/20 key is pressed, SP will be momentarily displayed.
S
XMIT FRONT
REAR
SAME SLOW
FAST LOCK
TARGET
PATROL
Fig 12
S
XMIT FRONT
REAR
SAME SLOW
FAST LOCK
TARGET
PATROL
Fig 13
Range (Sensitivity) Adjustment
The range (or sensitivity) of S
PATROL
is adjusted by
pressing the SEn key. This key cycles through the four (4) sensitivity
levels; SEn 1, SEn 2, SEn 3, and SEn 4 (Fig 14 - Fig 17,
respectively). In each case, the center display refers to the current
sensitivity setting. The shortest range is SEn 1 (Fig 14), and the
longest range is SEn 4 (Fig 17). The range (or sensitivity) must be
set for same lane moving mode and opposite lane
moving/stationary mode separately. While in each mode, (same
lane and opposite lane), indicated by the presence or absence of the
SAME icon, set each sensitivity as described above.
levels; SEn 1, SEn 2, SEn 3, and SEn 4 (Fig 14 - Fig 17,
respectively). In each case, the center display refers to the current
sensitivity setting. The shortest range is SEn 1 (Fig 14), and the
longest range is SEn 4 (Fig 17). The range (or sensitivity) must be
set for same lane moving mode and opposite lane
moving/stationary mode separately. While in each mode, (same
lane and opposite lane), indicated by the presence or absence of the
SAME icon, set each sensitivity as described above.
S
XMIT FRONT
REAR
SAME SLOW
FAST LOCK
TARGET
PATROL
Fig 14
S
XMIT FRONT
REAR
SAME SLOW
FAST LOCK
TARGET
PATROL
Fig 15
S
XMIT FRONT
REAR
SAME SLOW
FAST LOCK
TARGET
PATROL
Fig 16
S
XMIT FRONT
REAR
SAME SLOW
FAST LOCK
TARGET
PATROL
Fig 17
10