Deister Electronic GmbH TSU200 用户手册
6. Installation Notes
For a standard installation in a passenger-car car park, a TSU 200 can be installed either
beside the roadway, or above it.
beside the roadway, or above it.
6.1 Installation on the side of the road:
The reader is mounted on a pole on the driver's side next to the road at a height of 1.8 m
– 2.0 m (5.9 – 6.5 ft.). Then the reader is aligned towards the transponder/car windshield.
When a ground loop is present, it should be used to trigger the reader. The distance from
the reader to the ground loop should be in the range of 2.0 m - 2.5 m (6.5 – 8.2 ft.).
– 2.0 m (5.9 – 6.5 ft.). Then the reader is aligned towards the transponder/car windshield.
When a ground loop is present, it should be used to trigger the reader. The distance from
the reader to the ground loop should be in the range of 2.0 m - 2.5 m (6.5 – 8.2 ft.).
6.2 Installation above the road
The reader should not be installed higher than 3.0 m (9.8 ft.) above the road. The distance from
the reader to the groundloop should be in the range of 1.5 m - 2.5 m (4.9 – 8.2 ft.). The reader is
slightly tilted towards the vehicle windshield, so that the reader is almost vertically aligned with the
windshield.
the reader to the groundloop should be in the range of 1.5 m - 2.5 m (4.9 – 8.2 ft.). The reader is
slightly tilted towards the vehicle windshield, so that the reader is almost vertically aligned with the
windshield.
Note: The antenna beam of the reader shall in no case be restricted by objects above or below
the reader. Flush mounting is not recommended! If other types of vehicles (trucks, small cars etc)
need to be identified, the reader must be installed and aligned individually.
the reader. Flush mounting is not recommended! If other types of vehicles (trucks, small cars etc)
need to be identified, the reader must be installed and aligned individually.
Zulassung_wi_en_ts_tsu-200_pro_v140205_te_bf
13
6.5 ft. – 8.2 ft.
5.9 ft. – 6.5 ft.
Ground Loop
4.9 ft. – 8.2 ft.
max. 9.8 ft.
Ground Loop