Chamberlain Wireless Products Inc. RX900 用户手册
2
Output Timing
Dipswitch
Dipswitch
Time
#4
#5
OFF
OFF
0.5 Sec
ON
OFF
5 Sec
OFF
ON
1 Min
ON
ON
Toggle
Channel 1:
Dipswitch
Dipswitch
Time
#6
#7
OFF
OFF
0.5 Sec
ON
OFF
5 Sec
OFF
ON
1 Min
ON
ON
Toggle
Channel 2:
Program
NOTE: If the Receiver will be programmed with a
GCU or an accessory proceed to Program with GCU
or Program Accessories.
The following steps apply only if the Receiver will be
used by itself.
GCU or an accessory proceed to Program with GCU
or Program Accessories.
The following steps apply only if the Receiver will be
used by itself.
Step 1: Ensure the Receiver
does not have power and
Dipswitch #1 is set to the OFF
position.
NOTE: If Receiver is in this Mode, there can be no
other 900 Mhz units in the network.
does not have power and
Dipswitch #1 is set to the OFF
position.
NOTE: If Receiver is in this Mode, there can be no
other 900 Mhz units in the network.
Step 2: Connect power (as shown in Setup: Power
Connections).
Connections).
Step 3: Within 15 seconds, press and hold a button
on a remote control transmitter. The receiver will buzz
indicating programming is successful.
on a remote control transmitter. The receiver will buzz
indicating programming is successful.
Additional Remote Control Transmitters:
To program additional remote control transmitters,
repeat Step 3 above with each remote control
transmitter (within 10 seconds of each other) or
repeat Steps 1-3.
To program additional remote control transmitters,
repeat Step 3 above with each remote control
transmitter (within 10 seconds of each other) or
repeat Steps 1-3.
When all the remote control transmitters have been
programmed, wait 15 seconds for the Receiver to
leave Learn Mode. The Receiver will buzz twice
indicating it is ready for use.
programmed, wait 15 seconds for the Receiver to
leave Learn Mode. The Receiver will buzz twice
indicating it is ready for use.
Output Timing
Dipswitch
Dipswitch
Time
#4
#5
OFF
OFF
0.5 Sec
ON
OFF
5 Sec
OFF
ON
1 Min
ON
ON
Toggle
Channel 1:
Dipswitch
Dipswitch
Time
#6
#7
OFF
OFF
0.5 Sec
ON
OFF
5 Sec
OFF
ON
1 Min
ON
ON
Toggle
Channel 2:
Dipswitch
Dipswitch
Time
#2
#3
OFF
OFF
0.5 Sec
ON
OFF
5 Sec
OFF
ON
1 Min
ON
ON
Toggle
Channel 3:
Dipswitch
Time
#8
OFF
0.5 Sec
ON
5 Sec
Channel 4:
Program with Gate Control
Unit (GCU)
Unit (GCU)
NOTE: The Dipswitches on the
Receiver can be accessed by
removing the screw on the
bottom of the Receiver.
Receiver can be accessed by
removing the screw on the
bottom of the Receiver.