Chamberlain Wireless Products Inc. RX900 用户手册
3
Door Strike or Magnetic Lock
Step 1: Connect relays (as shown in Setup: Relay
Outputs and the charts below).
Outputs and the charts below).
NOTE: If a Door Strike is used, a separate power
supply is required.
If a Magnetic Lock is used, use the Normally Closed
connections (see below).
supply is required.
If a Magnetic Lock is used, use the Normally Closed
connections (see below).
1
3
2
4
5
6
7
8
9 10 11
DC
AC
+
-
COM
N/C
Door
Strike
Strike
Transformer/
Power Supply
Power Supply
Optional external power
input 10-24 Vac or DC
input 10-24 Vac or DC
Door Strike- Normally Open (N/O) Connection
N/O
1
3
2
4
5
6
7
8
9 10 11
+
-
COM
N/C
Magnetic
Lock
Lock
Transformer/
Power Supply
Power Supply
Magnetic Lock- Normally Closed (N/C) Connection
DC
AC
Optional external power
input 10-24 Vac or DC
input 10-24 Vac or DC
N/O
GCU
GCU
Program Accessories
Single Pushbutton Control (WPB1LM)
Step 1: Connect relays (as shown in Setup: Relay
Outputs).
Outputs).
Step 2: Connect power (as shown in Setup: Power
Connections).
Connections).
Step 3: Press and Release the
Learn button on the Pushbutton
Control.
Learn button on the Pushbutton
Control.
The Receiver will buzz and the LED
will blink 3 times indicating
programming is successful.
If the memory in the Pushbutton Control needs to be
cleared, press the Learn button until a tone is heard.
will blink 3 times indicating
programming is successful.
If the memory in the Pushbutton Control needs to be
cleared, press the Learn button until a tone is heard.
Refer to the Pushbutton Control manual for mounting
and operating instructions.
and operating instructions.
Gate Access Panel (GAPLM)/Keypad
Step 1: Connect relays (as shown in Setup: Relay
Outputs).
Outputs).
Step 2: Connect power (as shown in Setup: Power
Connections).
Connections).
Step 3: On the GAPLM or Keypad, enter Master PIN
Number, followed by the Receiver Identity (1-4) as
determined in Setup: Additional Receivers.
Number, followed by the Receiver Identity (1-4) as
determined in Setup: Additional Receivers.
The Receiver will buzz and the LED will blink 3 times
indicating programming is successful.
indicating programming is successful.
Refer to the GAPLM/Keypad manual for mounting
and operating instructions.
and operating instructions.
1
2 3
4
5 6
7 8 9
0 #
a c
OR
Installation
Step 1: Reattach cover with screw.
Step 2: Mount the Receiver with
the Terminal Block at the bottom
and the antenna hanging straight
down.
the Terminal Block at the bottom
and the antenna hanging straight
down.
NOTE: Metal surfaces can shorten the
range of the Receivers. If mounting on a metal
surface and long range is required, use a
non-metallic spacer to move the Receiver away from
the metal surface.
range of the Receivers. If mounting on a metal
surface and long range is required, use a
non-metallic spacer to move the Receiver away from
the metal surface.