JVC KENWOOD Corporation 378703 用户手册

8

■

  An ID code is a combination of a 3-digit Fleet number and a 4-digit ID number.  

Each transceiver must have its own Fleet and ID number.

•  Enter a Fleet number (00 ~ 349) to make a group call.
•  Enter an ID number (000 ~ 4999) to make an individual call in your fleet.
•  Enter a Fleet number to make a call to all units in the selected fleet (Fleet call).
•  Enter an ID number to make a call to the selected ID in all fleets (Supervisor call).
•  Select “ALL” Fleet and “ALL” ID to make a call to all units (Broadcast call).

Note:  The ID range may be limited by programming.

You can send and receive 2-digit Status messages which may be decided in your 

talk group.  Messages can contain up to 6 alphanumeric characters.  Status 

messages range from 0 to 99 (80 ~ 99 are reserved for special messages).
A maximum of 5 received messages can be stored in the stack memory of your 

transceiver.  These saved messages can be reviewed after reception.  Depending 

on your dealer settings, when the stack memory is full, either the oldest message 

will be erased when a new message is received or the new message will not be 

stored in the stack memory.  The   icon lights when a message is stored in the 

stack memory.

■

1  Select your desired zone and channel.
2  Press the key programmed as Status to enter Status mode or Selcall + 

Status to enter Selcall mode.

•  When using the 

Status key to enter Status mode, the target Fleet/ ID is fixed and 

cannot be selected.  Skip to step 5 to continue.

3  In Selcall mode, press the  /  keys to select the ID of the station you want 

to call.

•  If Manual Dialing is enabled, you can enter the station ID by using the 

microphone keypad, or by using 

the  /  keys.  When using the  /  keys, 

cycle through the digits to select a digit, then press the 

 key to set 

the digit and move the cursor to the right.  Repeat this process until the 

entire ID is entered.

4  Press the 

 key enter Status mode.

5  Press the  /  keys to select the status ID you want to transmit.

•  If Manual Dialing is enabled, you can enter the station ID by using the 

microphone keypad, or by using 

the  /  keys.  When using the  /  keys, 

cycle through the digits to select a digit, then press the 

 key to set 

the digit and move the cursor to the right.  Repeat this process until the 

entire ID is entered.

6  Press the microphone PTT switch or the 

 key to initiate the Status call.

•  “<<COMPLETE>>” is displayed when the call has been successfully transmitted.