JVC KENWOOD Corporation 407110 用户手册
7
GETTING ACQUAINTED 2
—— A ——
While receiving, the meter serves as an S-meter to
measure and display the received signal strength.
While transmitting, it serves as a power meter plus an
ALC meter, an SWR meter, or a Speech Processor
compression meter. The Peak Hold function holds
each reading for approximately half a second. While
adjusting the IF filter bandwidth, the meter displays an
adjustment state.
measure and display the received signal strength.
While transmitting, it serves as a power meter plus an
ALC meter, an SWR meter, or a Speech Processor
compression meter. The Peak Hold function holds
each reading for approximately half a second. While
adjusting the IF filter bandwidth, the meter displays an
adjustment state.
—— B ——
Appears when the Auto Mode function is ON and
while in Auto Mode frequency setup {page
while in Auto Mode frequency setup {page
53
}.
Displays the operating mode (USB, LSB, FM, AM,
CW, CWR, FSK, or FSR) {page 11}.
CW, CWR, FSK, or FSR) {page 11}.
Appears while in Menu mode {page 14}.
Appears while in Memory Scroll mode {page
44
}.
Appears while in Memory Channel mode or Memory
Scroll mode {page
Scroll mode {page
44
}.
In normal operating mode and various configuration
modes, it displays the Memory Channel number,
Quick Memory number, and entry log number. In
Menu mode, it displays the Menu No.
modes, it displays the Memory Channel number,
Quick Memory number, and entry log number. In
Menu mode, it displays the Menu No.
—— C ——
Appears while in Data mode {page 11} and while in
CW Morse Decoder mode {page 38}.
CW Morse Decoder mode {page 38}.
Appears while in narrow FM mode {page 11}.
Appears when the receiver pre-amplifier is ON {page
42
}.
Appears when the receiver’s attenuator is ON {page
42
}.
Appears when the Noise Blanker 1 or 2 is ON
{page
{page
42
}.
“
” (fast) or “
” (slow) appears when the
Automatic Gain Control function is ON. “
”
appears when the AGC is OFF {page
31
}.
Appears when IF filter A is selected {page
41
}.
Appears when IF filter B is selected {page
41
}.
—— D ——
“
” appears when manual notch is set to Normal.
“
” appears when Manual Notch is set to Wide.
“
” appears when Auto Notch is selected {page
41
}.
Appears when the Fine Tuning function is ON {page
31
}.
Appears when the MHz Step function is ON {page
30
}.
Also appears when the Quick Menu function is ON
{page 14}.
{page 14}.
“
” or “
” appears, depending on whether
DSP Noise Reduction 1 or Noise Reduction 2 is
selected {page
selected {page
41
}.
“
” appears when the RX Equalizer function is ON
{page
57
}. “
” appears when the TX Equalizer
function is ON {page
34
}.
“
” or “
” appears, when you select the DSP
Beat Cancel 1 or Beat Cancel 2 {page
41
}.
“ ” appears when the Tone function is ON {page
27
},
and blinks during Tone scan. “
” appears when the
CTCSS (Continuous Tone Coded Squelch System)
function is ON, and blinks during CTCSS scan {page
function is ON, and blinks during CTCSS scan {page
28
}. “
” appears when the Cross Tone function is
ON {page
29
}.
LCD DISPLAY
A
B
C
D
E
F