JVC KENWOOD Corporation 475501 用户手册
14
◆ The battery pack life is over when its operating time decreases even
though it is fully and correctly charged. Replace the battery pack.
INSTALLING THE ANTENNA
Antenna
Screw the antenna into the connector on
the top of the transceiver by holding the
antenna at its base and turning it clockwise
until secure.
the top of the transceiver by holding the
antenna at its base and turning it clockwise
until secure.
Note:
◆ The antenna is neither a handle, a key
ring retainer, nor a speaker/ microphone
attachment point. Using the antenna in these
ways may damage the antenna and degrade
your transceiver’s performance. la fi xer
correctement en place.
attachment point. Using the antenna in these
ways may damage the antenna and degrade
your transceiver’s performance. la fi xer
correctement en place.
INSTALLING THE BELT CLIP
Belt clip
If necessary, attach the belt clip
using the two supplied M3 x 8 mm
screws.
using the two supplied M3 x 8 mm
screws.
Note:
◆ If the belt clip is not installed, its
mounting location may get hot during
continuous transmission or when left
sitting in a hot environment.
continuous transmission or when left
sitting in a hot environment.
◆ Do not use glue which is designed to prevent screw loosening
when installing the belt clip, as it may cause damage to the
transceiver. Acrylic ester, which is contained in these glues,
may crack the transceiver’s back panel.
transceiver. Acrylic ester, which is contained in these glues,
may crack the transceiver’s back panel.