EMS Technologies Canada Ltd. HSD-128 用户手册
Page 4–78
18 September 2007
18 September 2007
SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
eNfusion™ HSD-128 High-speed Data Terminal
successfully loaded, and then the DOS window closes. This completes HPA
software load.
software load.
If all software loads are finished, verify the success of the software load by
following the instructions provided in "Verifying Software Loads" on page 4-78.
following the instructions provided in "Verifying Software Loads" on page 4-78.
14.
In the event that the load fails, restart the load from the beginning of "Loading
HPA Software" on page 4-76. If after two attempts, the load still does not complete
successfully, assume that the software disks may have been corrupted or the
software is incompatible with the hardware configuration. Contact EMS SATCOM
product support for assistance.
HPA Software" on page 4-76. If after two attempts, the load still does not complete
successfully, assume that the software disks may have been corrupted or the
software is incompatible with the hardware configuration. Contact EMS SATCOM
product support for assistance.
(5) Verifying Software Loads
After loading all software as specified in the applicable software service bulletin,
released by EMS Technologies, verify that all software loaded successfully.
released by EMS Technologies, verify that all software loaded successfully.
WARNING:
In systems with disabled or removed SDU, the channel card or cards
must be manually powered on to enable the verification of the software
load.
load.
To verify that software loaded successfully
1.
Apply power to the HSD.
2.
On the computer, open HyperTerminal and start the HSD Maintenance
Utility Program.
3.
Connect a computer to the Maintenance Port of the HSD transceiver.
4.
Enter the Maintenance Utility Program password: Type maint and then
press Enter.
The Maintenance Utility Program, Menu 1 appears.
5.
Press Ctrl+N to scroll to MENU 2.
Menu 2 appears.
MENU1 FIRMWARE Vx.x
X override forward id L test LEDs
Y explain hpa error status S set hcm attenuator
R hcm RF threshold
Y explain hpa error status S set hcm attenuator
R hcm RF threshold
<CTRL> N next menu <CTRL> O previous menu = select reports