Itron Inc. 24GZR 用户手册
TDC-0838-000 2.4GZ OpenWay Gas Module Installation Guide - Remote Mount
53
This chapter provides the instructions to install Remote 2.4GZ OpenWay Remote Mount
Gas Modules (Itron part number OWG-5001-501 and OWG-5002-501 with 2.5 foot cable
and encoder) on the diaphragm gas meters where a direct mount endpoint is not possible.
Reference the Itron Gas Endpoint Meter Compatibility List (PUB-0117-002 or the
Gas Modules (Itron part number OWG-5001-501 and OWG-5002-501 with 2.5 foot cable
and encoder) on the diaphragm gas meters where a direct mount endpoint is not possible.
Reference the Itron Gas Endpoint Meter Compatibility List (PUB-0117-002 or the
2.4GZ
OpenWay Remote Mount Gas Module Meter Compatibility List
on page 3 for compatible
diaphragm meters.
Tools and Materials Supplied By You
Note 2.4GZ OpenWay Remote Mount Gas Module installation to a diaphragm
meter may require additional tools and materials over those listed in
meter may require additional tools and materials over those listed in
Installation
Prerequisites
on page 7.
The following user/installer-supplied tools and materials are required to install, program,
and check the 2.4GZ OpenWay Remote Mount Gas Module:
and check the 2.4GZ OpenWay Remote Mount Gas Module:
• Medium flat-blade screwdriver for band clamps.
• Medium flat-blade, torque-measuring screwdriver for screws to attach adapter plates
• Medium flat-blade, torque-measuring screwdriver for screws to attach adapter plates
to pipe brackets and screws to attach endpoints to adapter plates. (Use torque
measured 9 to 12 inch-pounds.)
measured 9 to 12 inch-pounds.)
• Medium Philips screwdriver to attach endpoints to flat surfaces
• Pliers to secure cable ties.
• Side-cutting pliers or similar tool for removing excess cable tie ends.
• 1/4" nut driver or other blunt tool for seating endpoint tamper seals.
• FC200SR handheld with Endpoint-Link or Endpoint-Link Pro (version 5.3 or higher)
• Pliers to secure cable ties.
• Side-cutting pliers or similar tool for removing excess cable tie ends.
• 1/4" nut driver or other blunt tool for seating endpoint tamper seals.
• FC200SR handheld with Endpoint-Link or Endpoint-Link Pro (version 5.3 or higher)
for programming and checking endpoints.
• 1" putty knife or similar tool to remove old gasket material from the meter and index
cover.
• Replacement temperature compensation (TEMP COMP) meter index stickers (if
required).
C
H A P T E R
5
Diaphragm Meter Installation