VTech Telecommunications Ltd 80-5744-11 用户手册
29
Appendix
CAN’T
CONNECT
displays on my
handset.
CONNECT
displays on my
handset.
• Move the handset closer to the base. You might have moved out of
range.
The batteries
will not hold a
charge.
will not hold a
charge.
• Charge the battery in the handset for at least 16 hours. For optimum
daily performance, return the handset to its base when not in use.
• You may need to purchase a new battery, please refer to the batteries
section of this user’s manual.
• Your phone might be malfunctioning. Please refer to the warranty
section of this user’s manual for further instruction.
Troubleshooting
I get noise,
static, or weak
signal even
when I’m near
the base
static, or weak
signal even
when I’m near
the base
• Press the CHAN button while on a call until the interference has been
eliminated.
• Other electronic products can cause interference to your cordless
phone. Try installing your phone as far away from the following elec-
tronic devices as possible: wireless routers, radios, radio towers,
pager towers, cell phones, intercoms, room monitors, televisions,
personal computers, kitchen appliances and other cordless phones.
tronic devices as possible: wireless routers, radios, radio towers,
pager towers, cell phones, intercoms, room monitors, televisions,
personal computers, kitchen appliances and other cordless phones.
• Microwaves operate on the same frequency as your phone. It is nor-
mal to experience static on your phone while the microwave oven is
operating. Do not install this phone in the same outlet or near a micro-
wave oven.
operating. Do not install this phone in the same outlet or near a micro-
wave oven.
• If your phone is plugged in with a modem or a surge protector, plug
the phone (or modem/surge protector) into a different location. If this
solves the problem, re-locate your phone or modem farther apart
from one another, or use a different surge protector.
solves the problem, re-locate your phone or modem farther apart
from one another, or use a different surge protector.
• Relocate your phone to a higher location. The phone will likely have
better reception when not installed in a low area.
• If the other phones in your home are having the same problem, the
problem is in your wiring or local service. Contact your local tele-
phone company (charges may apply.)
phone company (charges may apply.)
• Reset the base. Unplug the unit’s electrical power. Wait for 15 sec-
onds then plug it back in. Allow up to one minute for the handset and
base to reset.
base to reset.
•
Other electronic products can cause interference to your cordless
phone. Try installing your phone as far away from these types of
electronic devices as possible: wireless routers, radios, radio towers,
pager towers, cell phones, intercoms, room monitors, televisions,
personal computers, kitchen appliances and other cordless phones.
phone. Try installing your phone as far away from these types of
electronic devices as possible: wireless routers, radios, radio towers,
pager towers, cell phones, intercoms, room monitors, televisions,
personal computers, kitchen appliances and other cordless phones.