Digital Security Controls Ltd. 15SCW9067 用户手册

LEGAL

Voltage

Input 100-240V (AC-DC converter)

frequency,

50/60hz

max. input current

0.68A Max

Voltage

output 12V,  2A

Battery Type

Lithium Ion Polymer battery

Lifetime Power Cycles

300+ Power Cycles ( fully charged to fully discharged state )

DC  voltage

8.4V max

battery model number

Springpower 704077

max. charging current

400mA

trickle charge current

50mA max

 battery capacity in ampere-hours

2500maH

Warning:  Battery Capacity Detection:  The battery will be automatically monitored for low battery capacity.  Warning messages will be sent to the Product and 

to the Alarm.com Backend informing the customer of the low battery condition (this occurs whenever the current battery capacity falls below 30% of the fully 

charged capacity).  The Product will also provide optional trouble beep warnings for the low battery conditions.  The Product warning messages can be viewed on 

the Security Status / Alerts Tab.  

Warning:  Battery Unplugged Detection:  The battery will be automatically monitored to detect occurrences of the battery being unplugged.  Warning messages 

will be sent to the Product and to the ADC Backend informing the customer of the unplugged battery.   The Product will also provide optional trouble beep 

warnings for the unplugged battery condition.  The Product warning messages can be viewed on the Security Status / Alerts Tab.  

Warning:  Battery Life:  Greater than 5 years with use of the Product according to specifications.  Change the battery after 5 years of service.  .  

Warning:  Battery Handling:  To maximize the life of the battery and for safety reasons the following precautions should be taken:

•

The aluminum  foil encasing the battery is delicate and should not be exposed to sharp objects such as knives, pins or sharp finger nails

•

The battery should not be exposed to water

•

Do not leave near a heat source. This will reduce the working life of the battery

•

Do not short circuit the battery by connecting the positive terminal to the negative terminal.  High currents can be generated resulting in high 

temperatures and risking fire and personal injury

The following warnings cover the likely potential situations that may cause False Alarms Reports (FAR) to be generated.  

Cause of FAR:  User fails to enter proper pass code or enters the wrong pass code while trying to disarm system.  

Prevention:  Carefully enter your passcode.  Remember your passcode and/or write it down in a safe place that is easily accessible.  

Cause of FAR:  User fails to exit premise before exit delay timer expires while trying to arm system in Away Mode.  

Prevention:  Listen to exit beeps and last 10 second voice countdown … if running out of time, then either press the Extend button to extend the exit delay or 

press cancel … and then start the rearming process again once you are ready to leave the premises.

Cause of FAR:  User opens a door, but fails to close the door before the exit delay timer expires while trying to arm system in Away Mode, thus causing an exit 

fault and alarm condition.  

Prevention:  Be careful to close the door tightly upon exit during the arming process.  If an exit fault / alarm does occur, then quickly reenter the home and 

disarm the alarm.  

Cause of FAR:  Erroneous fire detection alarm from sensor.    

Prevention:  During installation, system can be set to require two fire sensor detections prior to generating central monitoring station fire alarm … note a local fire 

alarm will still sound to alert the homeowner.  

Cause of FAR:  Erroneous Carbon Monoxide detection alarm from sensor.    

Prevention:  During installation, system can be set to require two Carbon Monoxide sensor detections prior to generating central monitoring station gas leak 

alarm … note a local fire alarm will still sound to alert the homeowner. 

© Last updated 2/18/15 All rights reserved