ADC Telecommunications Inc. FWM1901B 用户手册

ADCP-75-246 • Issue 1 • 6/2008

Page 16
© 2008, ADC Telecommunications, Inc.

2. Wrap the top section of strapping around the pole and secure using Panduit tool # BT1HT.

Adjust the tool tension setting to #7. Follow the instructions provided with the tool by the
tool manufacturer (see MS Strapping Tool Operation Instructions PA24808A01). 

3. Repeat step 2 for the bottom section of strapping. 

4. Hang the enclosure from the mounting bracket as shown in 

Use the following procedure to install the microBTS on the standard mounting bracket. 

1. Hang the enclosure from the mounting bracket as shown in 

. The shoulder screw

in the rear side of the enclosure fits into the notch at the top of the mounting bracket. 

2. Insert a 5/16 x 1-1/4-inch hex bolt through the hole in the mounting tab located at the

bottom of the enclosure. 

3. Place a 5/16-inch flat washer and 5/16-inch flat washer on the hex bolt. 

4. Thread a 5/16-inch nut onto the hex bolt and tighten securely. 

22632-A