TransCore IT241005422 用户手册

IT2410 Tag Programmer User Guide

D-22

Get/Set Communications Baud Rate

The Get Communications Baud Rate command requests programmer’s communica-
tions baud rate. The Set Communications Baud Rate command sets the programmer
RS–232 communications baud rate.

Upon command, the programmer changes its baud rate to the selected value immedi-
ately following the transmission of the command response. It is recommended that the
baud rate only be changed on the host after the programmer has received the acknowl-
edge so that communications are maintained.

Note: You might want to have a command in the host to let the user change the baud
rate when the programmer has been saved to a different baud rate than that of the host
default.

The data associated with the Get/Set Communications Baud Rate is shown in

Table D-19.

Table D-19 Communications Baud Rate Data

Value

Definition

0CH

19,200 bps

0DH

38,400 bps (factory default)

Get/Set Ethernet Parameters

The Get Ethernet Parameters command requests programmer’s Ethernet parameters.
The Set Ethernet Parameters command sets the programmer’s Ethernet parameters.
The data associated with the Get/Set Ethernet Parameters is shown in Table D-20.

IP addresses — Must be specified in valid dot format, such as 10.3.10.10.

Bits 7 - 0

Communications baud rate

Table D-20 Ethernet Parameters Data

Subcommand

Parameter

01H

MAC address

02H

Programmer IP address

03H

Host IP address

04H

Gateway IP address

05H

Network mask