Measurement Systems International Inc DL7200RFL 用户手册
M E A S U R E M E N T S Y S T E M S I N T E R N A T I O N A L
MSI-7200 Dyna-Link
•
User Guide Page 11
Remote units only: The “*” key functions as the CLEAR/CANCEL key during
all Set-Point and Setup functions.
all Set-Point and Setup functions.
General setup procedure
1a) Standard Dyna-Links
Remove the seal screw in the back of the Dyna-Link. Push the SETUP/
CAL switch found inside the hole. A long thin insulated screwdriver or
wood “Q-tip” stick is a good tool for this purpose. The Dyna-Link will
display “Unit”.
CAL switch found inside the hole. A long thin insulated screwdriver or
wood “Q-tip” stick is a good tool for this purpose. The Dyna-Link will
display “Unit”.
1b) Remote Dyna-Links
Turn the power off. Remove the batteries from the Dyna-Link. Remove
the four hex head screws holding the faceplate to the yellow handle
enclosure. Carefully lift out the electronics/faceplate assembly. After
ensuring that the electronics package is not shorting against the case or
any other metallic surface, replace the batteries and turn the power back
on. Push the SETUP/CAL switch (SW4) located on the lower board and
proceed as below. When the setup parameters you desire are entered,
reassemble the unit with the batteries out.
the four hex head screws holding the faceplate to the yellow handle
enclosure. Carefully lift out the electronics/faceplate assembly. After
ensuring that the electronics package is not shorting against the case or
any other metallic surface, replace the batteries and turn the power back
on. Push the SETUP/CAL switch (SW4) located on the lower board and
proceed as below. When the setup parameters you desire are entered,
reassemble the unit with the batteries out.
2) Options are viewed by repeated pushes of the UP or DOWN keys.
3) To change a parameter or initiate Calibration, push the ENTER
3) To change a parameter or initiate Calibration, push the ENTER
(POWER) key. Selections are stored with the ENTER (POWER) key.
4) Selecting CLEAR/CANCEL in most cases will cancel the current
operation (and not save any changes to that function). It is also used to
clear digits or values during numeric entry. CLEAR/CANCEL can be
used to exit Setup altogether and return to normal operation.
clear digits or values during numeric entry. CLEAR/CANCEL can be
used to exit Setup altogether and return to normal operation.
5) In general, when the display is flashing, you are being prompted to use
the ENTER (POWER) key to finish an operation, or to use the UP or
DOWN key to select a different option.
DOWN key to select a different option.
CLEAR/CANCEL
CLEAR/CANCEL is initiated by pushing both the ZERO key and the PEAK
key simultaneously (Remote units can use the “*” key as a Clear/Cancel key).
Alternately push the SETUP/CAL key through the hole in the rear panel.
key simultaneously (Remote units can use the “*” key as a Clear/Cancel key).
Alternately push the SETUP/CAL key through the hole in the rear panel.
END
To exit from the Setup Menu push CLEAR/CANCEL or scroll to the “End”
message and push ENTER (POWER).
message and push ENTER (POWER).