Wulfsberg Electronics Division 2000-UHF1 用户手册

Wulfsberg Electronics

P-2000 and C-2000/RT-2000 Operator’s Manual

Document 150-041102 Revision A

Page 32 of 37

The P-2000 comes from the factory already configured for a normal installation; however, there are several options
the operator can select.  These options are very simple to update.  The process is as follows:

•  Ensure you are on the HOME PAGE and press the PROG button.  If prompted, enter the password #1 (In the

system programming, the user has the option of eliminating this password by setting it to “0000”)

•  Highlight the SYSTEM option and press the ENTER button.  You will be prompted to enter the system

password.  After successful entry of the system password the SYSTEM SETUP page will be displayed.

•  On System Setup Page 1, users can configure the Label field (instead of FM1 or FM2, the user could input

VHF1, MAIN, OPS or anything that helps the operators properly select transceivers), and the passwords.
Password #1 will not appear in any operations if it set to “0000”.

•  To display page 2, highlight the NEXT option and press ENTER.

•  The second setup page allow the selection of the following:

•  Enable Standby – the active/standby channel operation can be set to active only by saying “YES” to this

option.  A “NO” will eliminate the standby channel and the user will tune active channels only.  Factory
default for this option is “YES”.

•  Lock QMEM – To keep users from altering the QMEM settings, this option can be set to YES.  Factory

default for this option is “NO”.