Biolase Inc. EPIC 用户手册
36 |
P a g e
5 4 0 0 3 2 1 R e v . X : D R A F T
Section 8: MAINTENANCE
Annual Maintenance
The
EPIC 10
should be serviced annually by a qualified, trained, and certified technician.
Annual calibrations can be performed at a certified depot repair facility. Call Biolase Service
at 1-800-321-6717 or your Authorized Service Representative to schedule an appointment.
Please contact Biolase Service at 1-800-321-6717 or your Authorized Representative to
discuss Extended Service Contracts and Annual maintenance options.
at 1-800-321-6717 or your Authorized Service Representative to schedule an appointment.
Please contact Biolase Service at 1-800-321-6717 or your Authorized Representative to
discuss Extended Service Contracts and Annual maintenance options.
Daily Maintenance
Use peel-off clear covers supplied with the system. Use disinfectant to wipe down the front
panel and handpiece holder of the
Use peel-off clear covers supplied with the system. Use disinfectant to wipe down the front
panel and handpiece holder of the
EPIC 10
system after each procedure. Do not use
bleach or abrasive cleansers.
Check and clean the protective window of the fiber optic shaft with cotton swab wet in
alcohol.
Check and clean the protective window of the fiber optic shaft with cotton swab wet in
alcohol.
Contamination Control Procedures
The contamination control suggested for the
EPIC 10
surgical handpiece and tips is the
steam sterilization method. However, before sterilization, the
EPIC 10
reusable handpiece
should be carefully cleaned per the following procedure.
NOTE:
The fiber optic cable and Handpiece are delivered from the manufacturer as
non-sterile.
NOTE:
Tips are designed to withstand a single sterilization cycle and must be
disposed of after single use in a biohazard medical waste sharps container.
Cleaning Instructions for the Surgical Handpiece, the Classical (Feed-Through) Fiber
Handpiece, and the Reusable Fiber Optic Cable
The cleaning process is intended to remove blood, protein and other potential contaminants
from the surfaces and crevices of reusable accessories. This process may also reduce the
quantity of particles, microorganisms and pyrogens present. Cleaning should be performed
prior to sterilization and must be conducted only by qualified office personnel trained to
perform the procedure and handle the
Handpiece, and the Reusable Fiber Optic Cable
The cleaning process is intended to remove blood, protein and other potential contaminants
from the surfaces and crevices of reusable accessories. This process may also reduce the
quantity of particles, microorganisms and pyrogens present. Cleaning should be performed
prior to sterilization and must be conducted only by qualified office personnel trained to
perform the procedure and handle the
EPIC 10
Fiber optic Delivery System.
Wear protective latex gloves when handling the contaminated delivery system.
To clean the fiber cable, wipe the entire cable, including the shaft, with cotton gauze and
chemical disinfectant. Keep the window intact. If the window is dirty, clean with a cotton
swab wet with alcohol.
To clean the fiber cable, wipe the entire cable, including the shaft, with cotton gauze and
chemical disinfectant. Keep the window intact. If the window is dirty, clean with a cotton
swab wet with alcohol.