VTech Electronics Limited 1588 用户手册

Stylus Fastener 

Use the stylus string to attach the stylus to this 
fastener.

 

Slide these switches to open the battery doors. 
Always replace the 

InnoTab

® 

3S battery doors 

after changing batteries.

microSD Memory Card Slot 

Insert a microSD memory card (not included). 
(NOTE: 

InnoTab

® 

3S  is  compatible  with 

microSD memory cards up to 32GB.)

Battery Compartments 

Insert  4  "AA"  batteries  or  the  rechargeable 
battery  packs.  For  battery  installation 
instructions, please see the section below.

Installing the Rechargeable Battery Packs

1.  Make sure the InnoTab® 3 or InnoTab® 3S is turned off.
2.  Turn the unit over. Slide the battery door lock switch (or switches) forward 

and push the battery covers off to each side to remove them.

3.  Remove  any  old  batteries  that  may  be  in  the  toy.  (Battery  removal  and 

replacement should be done by an adult.)

4.  Insert Battery Pack① into the compartment on the right side and Battery 

Pack② into the compartment on the left side.

 • Insert the battery pack into the connector slot first.
 • Then press the battery pack down until it rests in place.
5.  Replace the battery covers.

Charging and Recharging the Batteries

The rechargeable batteries should be fully charged before the first use. To charge 
and recharge the batteries, please follow the instructions below.
1. Make sure the battery packs are installed in the tablet.
2. Plug one end of the AC adapter into the power jack on the 

InnoTab

®

 and plug 

the other end into a wall outlet. 

Battery Door Lock Sliding 
Switches