HARRIS CORPORATION MBS800B075 用户手册

MM102225V1, Rev. B 

This section describes post installation tests required for compliance testing of the M/A-
COM Wireless Systems OpenSky Digital Base Station. This section defines and details 
the test plan and methodology for each test. 

Objective:  This test confirms a base site receive channel is not corrupted by site specific 
noise or interference. Site installation and site gain optimization should be completed 
before this test is performed. The NIMCAS site optimization program provides an 
expected difference between terminated and antenna connected quieting tests. Measured 
results should be within 2 dB of this value. 

This section covers tests that perform two functions: 

•  Verify that all contractual requirements as detailed in the system Requirements 

Traceability  Verification  Matrix, (RTVM), are met. These tests are identified as 
mandatory and are linked to the relevant section for the RTVM. 

•  Ensure that the site, as installed, is operating at optimum performance. These tests are 

not mandatory but clearly have impact on some of those that are.  

To ensure that the system is installed and configured correctly, the following procedures 
must be performed. In addition, several tests are performed to validate the RF 
performance of the station and to ensure compliance with the station FCC license. 

This section is therefore divided into the following areas: 

•  Verification Testing 
•  Equipment Configuration 
•  Compliance Testing 
•  Performance Testing 
•  Operational Testing 
•  Network Connectivity  
•  Final Operating Capability 
•  Appendices:  Supplemental information on equipment configuration and control 

access. 

⇒  Base Site Configuration Procedure should also be consulted for configuration 

questions (see APPENDIX F - TYPICAL BASE STATION 
CONFIGURATION). 

⇒  Installed Site Cavity Tuning Procedure should also be consulted for Filter Tuning 

(see APPENDIX H - VERIFICATION TESTING – TRANSMIT FILTER 
TUNING).